- March 1st, 2022, 7:27 am#4967748
I decided to go a different route with my Ecto Goggles. I looked up the AN/PVS-5a Night Vision goggles and noticed that the knobs on the side were different than what was used on the prop. So I went and made my own and just need some cleanup after I 3D printed them. Here's a couple of photos. 
and 
and ccv66 liked this
Virgo. Avid skier. Gluten-full. And 100% jazzed to meet you. -- Jillian Holtzmann
- By The_Y33TER
- By DKChris
- By edspengler