- February 16th, 2022, 8:29 am#4967329
Has anyone out there ever done a set of measured drawings or a set of STLs for a Bacharach Sniffer?
My brother and I been teaching ourselves 3-D drawing, and I was thinking the Bacharach would be a good starter project.
So far I've just been trying to take proportional measurements off of reference photos, and I'm guessing the body is ~ 10 x 7 1/2 x 3 1/2 inches over all . If anyone out there has a real one to pull numbers from it would be helpful.
I've love to make this at open source project, and I'm planning to post whatever I come up with on Thingiverse.
My brother and I been teaching ourselves 3-D drawing, and I was thinking the Bacharach would be a good starter project.
So far I've just been trying to take proportional measurements off of reference photos, and I'm guessing the body is ~ 10 x 7 1/2 x 3 1/2 inches over all . If anyone out there has a real one to pull numbers from it would be helpful.
I've love to make this at open source project, and I'm planning to post whatever I come up with on Thingiverse.
wralex liked this